CORCOM Product Guide  
					Two-Stage General Purpose RFI Power Line Filter  
					R Series  
					VR7/ER7  
					VR3/ER3  
					UL Recognized  
					CSA Certified  
					VDE Approved  
					10VR6  
					VR1/ER1  
					R Series  
					Specifications  
					Maximum leakage current,each line-to-ground  
					VR Models  
					The dual T section RFI power line filters provide premium  
					performance at moderate cost. They are well suited for low  
					impedance loads where noisy RFI environments are  
					present. They control pulsed, continuous and/or intermittent  
					interference, providing protection to your equipment from  
					power line noise in addition to protecting the line from  
					equipment noise. The R series dual T type provides low  
					leakage current without deterioration of insertion loss  
					characteristics and at a competitive cost. The ER models  
					meet the low leakage current requirements of VDE portable  
					equipment, and (120 Volt) UL2601 non-patient medical  
					equipment.  
					ER Models  
					.21 mA  
					.36 mA  
					@ 120 VAC 60 Hz:  
					@ 250 VAC 50 Hz:  
					Hipot rating (one minute):  
					line-to-ground  
					line-to-line  
					Operating frequency:  
					.4 mA  
					.7 mA  
					2250 VDC  
					1450 VDC  
					50/60 Hz  
					Rated voltage (max.):  
					250 VAC  
					Minimum insertion loss in dB:  
					Line-to-ground in 50 ohm circuit  
					Current  
					Frequency–MHz  
					Electrical Schematic  
					Rating  
					.15  
					.5  
					1
					5
					10  
					30  
					VR Models  
					1A, 3A  
					2A, 5A, 10A, 20A  
					30  
					5
					65  
					44  
					65  
					60  
					65  
					65  
					65  
					65  
					65  
					60  
					LINE  
					LOAD  
					ER Models  
					1A, 3A  
					2A, 5A, 10A, 20A  
					25  
					2
					60  
					35  
					65  
					51  
					65  
					63  
					65  
					60  
					65  
					50  
					Resistor location for reference only.  
					Line-to-line in 50 ohm circuit  
					Current  
					Rating  
					Frequency–MHz  
					Case Style  
					.15  
					.5  
					1
					5
					10  
					30  
					20VR6  
					VR, ER Models  
					1A, 3A  
					2A, 5A, 10A, 20A  
					Note: Same layout for 20VR1 and 20ER1, except .250 [6.35] (5) terminals  
					–
					–
					–
					–
					65  
					35  
					60  
					60  
					54  
					57  
					46  
					45  
					replace Screw Terminals of 20VR6.  
					.250  
					.156  
					Slots:  
					x
					3.96  
					Terminals: No. 8-32 (5)  
					(4)  
					6.35  
					E
					D B  
					2.00  
					50.8  
					A
					C
					Torque 18 2 in.lb  
					84  
					Catalog 1654001  
					Revised 05-07  
					Dimensions are in inches and  
					millimeters unless otherwise  
					specified. Values in italics  
					are metric equivalents.  
					Dimensions are shown for  
					reference purposes only.  
					Specifications subject  
					to change.  
					USA Cust. Svc.: 1-800-468-2023  
					CORCOM Prods: 1-847-680-7400  
					www.corcom.com  
					www.tycoelectronics.com  
					Germany:  
					49-89-6089-0