Absolute encoders - parallel
Hollow shaft max. ø14 mm
Multiturn encoder 12 bit ST / 12 bit MT
GXP1H - parallel
Terminal significance
Terminal assignment
UB
Encoder voltage supply.
Connector
Pin 1
Core colour Assignment
GND
Encoder ground connection relating to UB.
white
Output D0
Output D1
Output D2
Output D3
Output D4
Output D5
Output D6
Output D7
Output D8
Output D9
Outputs
D0-D23
24 parallel output signals.
Pin 2
brown
green
yellow
grey
For PNP it is recommended to utilize pull-
down resistors for every data line, for NPN
pull-up resistors of 4.7 kΩ.
Pin 3
Pin 4
Pin 5
Outputs
D19 - D23
Special outputs
With inferior resolutions these outputs
may be configurated as special outputs.
Pin 6
pink
Pin 7
black
Zero setting
Input for setting a zero point anywhere
within the programmed encoder resolution.
The zero setting operation is triggered by a
High impulse and has to be in line with the
selected direction of rotation (UP/DOWN).
Connect to GND after setting operation for
maximum interference immunity. Impulse
duration >100 ms.
Pin 8
violet
Pin 9
grey/pink
red/blue
Pin 10
Pin 11
Pin 12
Pin 13
Pin 14
Pin 15
Pin 16
Pin 17
Pin 18
Pin 19
Pin 20
Pin 21
Pin 22
Pin 23
Pin 24
Pin 25
Pin 26
Pin 27
Pin 28
Pin 29
Pin 30
Pin 31
Pin 32
Pin 33
Pin 34
Pin 35
Pin 36
Pin 37
white/green Output D10
brown/green Output D11
white/yellow Output D12
yellow/brown Output D13
UP/DOWN
UP/DOWN counting direction input.
Without potential this input is on High.
UP/DOWN High means ascending output
data with clockwise hollow shaft rotation
when looking at flange. UP/DOWN-Low
means ascending values with counterclo-
ckwise shaft rotation when looking at
flange.
white/grey
grey/brown
white/pink
pink/brown
white/black
Output D14
Output D15
Output D16
Output D17
Output D18
brown/black Output D19
ENABLE
STORE
Input for activating the output drivers that
are triggered by input level Low. Upon
being on High (or less potential) the output
drivers switch to high-impedance (Tristate).
grey/green
yellow/grey
pink/green
yellow/pink
–
Output D20
Output D21
Output D22
Output D23
Input for output data storage. Upon a Low
input level the encoder data are stored in
the intermediate memory. Upon being on
High (or less potential) the current encoder
position data are switched to the output
drivers. This line must be applied for
reliable data readout in binary code.
–
–
–
yellow/blue
brown/blue
brown/red
green/blue
–
Zero setting
ENABLE
STORE
RxD
TxD
Encoder receiver input for RS232 program-
ming interface.
UP/DOWN
–
Encoder transmitter output for RS232
programming interface.
–
–
–
–
white/blue
white/red
red
TxD
RxD
UB
GND
blue
www.baumerivo.com
3
