Series 09VR  
					9mm Panel Potentiometer  
					Electrical Specifications  
					Min  
					-20  
					Typical  
					Max  
					+20  
					Unit  
					%
					Total Resistance Tolerance  
					–
					Power Rating  
					–
					–
					+0.05  
					–
					+300  
					–
					–
					+20  
					–
					watt  
					VDC  
					Ω
					mV  
					MΩ  
					Operating Voltage  
					Residual Resistance  
					Slider Noise  
					Insulation Resistance  
					Dielectric Strength  
					Taper  
					–
					–
					+100  
					250 VDC for 1 min.  
					+100  
					250 VAC for 1 min. no arcing  
					Linear and audio options (see charts)  
					Mechanical  
					Total Mechanical Travel  
					280° ± 5°  
					300° ± 5°  
					Operating Torque  
					Starting Torque  
					Shaft Wobble  
					Bushingless  
					10 to 80 gf-cm  
					100 gf-cm max.  
					0.8 x L/20mm p-p max.; L = Shaft Length  
					0.5 x L/20mm p-p max.; L = Shaft Length  
					5 kgf for 3 sec.  
					With Bushing  
					Shaft Push-Pull Strength  
					Stop Strength  
					Detent Position  
					280° travel  
					3 kgf-cm min.  
					140° ± 5°  
					150° ± 5°  
					30 to 300 gf-cm  
					5,000 cycles  
					6 kgf-cm  
					300° travel  
					Detent Torque  
					Rotational Life  
					Panel Nut Tightening Torque  
					IP Rating  
					40  
					Mounting Hardware  
					Packaging  
					Weight  
					One flat washer and one mounting hex nut supplied with bushing option  
					Bulk  
					2 grams  
					Environmental  
					Min  
					-10  
					-30  
					Typical  
					Max  
					+70  
					+70  
					Unit  
					°C  
					°C  
					Operating Temperature  
					–
					–
					Storage Temperature  
					Soldering Conditions  
					Wave Solder  
					Preheat: 100°C max for 2 min max; Solder temperature: 260°C ± 5°C for 5 sec max.;  
					No clean foam flux recommended  
					Manual Solder  
					Wash  
					Moisture Sensitivity Level  
					ESD Classification (HBM)  
					350°C ± 5°C for 3 sec max.; Sn95Ag5 no clean solder  
					Not recommended  
					1
					Not applicable  
					All testing is performed at room ambient conditions except as noted. Users should verify device actual performance in their specific applications .  
					This product is compliant to RoHS3 Directive 2015/863 Amendments of Annex II on 31 March 2015, and REACH SVHC Directive EC 1907/2006 Amendments of  
					Annex XIV & Annex XVII on 15 January 2018.  
					Custom and value-added options available on request. Please contact your sales representative for additional information.  
					2019-08-22 Rev. B  
					Page 2 of 7  
					© 2019 CTS® Corporation. Information/product(s) subject to change. No warranty that product(s) will meet the stated specifications for customer specific applications or test  
					equipment. Visit www.ctscorp.com for list of applicable patent(s), more information, or to request a quote.